Changes between Version 5 and Version 6 of DemoGuide

Timestamp:

Nov 19, 2008, 4:22:04 PM (15 years ago)

Author:

baumgart

Comment:

--

DemoGuide

@@ -11 +11 @@
 == Things you can try ==
 
- * Watch the load avarage of a PlanetLab node by clicking on an icon on the monitor page.
- * Make a test call from the management node to any of the PlanetLab nodes: Click on a icon on the monitor page and click on the "Call this node" link. This will open a new window showing the call setup latency (from the initial SIP INVITE to the 200 OK) and the number of SIP retransmissions.
+ * Watch the load avarage of a !PlanetLab node by clicking on an icon on the monitor page.
+ * Make a test call from the management node to any of the !PlanetLab nodes: Click on a icon on the monitor page and click on the "Call this node" link. This will open a new window showing the call setup latency (from the initial SIP INVITE to the 200 OK) and the number of SIP retransmissions.
  * You can try a test call with you local SIP client: Simply click on a icon on the monitor page and look for the registered SIP name ''sip:xxx@p2pname.org''. Dial this name with your SIP UA and you should get connected to the echo test service on this node.
  * Register a new SIP user in the P2PSIP overlay with your local SIP client: Configure p2pname.org:5061 as registrar and outgoing SIP proxy and choose an arbitrary user name with empty password.
+ * Use the command interface from the monitor page to control a P2PNS node. You could e.g. try to lookup the siblings to a key using different routing modes and compare the measured lookup latency.